Jump to content



1 reply to this topic

#1 Codeman



  • Members
  • 12 posts

Posted 22 January 2019 - 12:28 PM

I have an infinus that Im having issues with. I threw instructions of course. I wired in parallel to the stock battery a xt60 plug to run a 4 cell sub c NiCd pack and ran that on its own. So the voltage is 5.3ish off charger. I tried the blaster and seemed to fire ok maybe a little less boggy then stock. Now the issue is Ill use auto load feature and it will load a few and then stop. No led light push dart load switch wont start feeder flywheels wont rev. It wont cycle when you remove drum. You open and close jam door and it cycles and you can fire. Then same thing load a few and shut down. I then tried on alkaline without nicd and worked fine at 6.1v. So Im wondering if anyone knows does the blaster shit down with low voltage since 4 alkaline would likely never get much below 5v and thats why it works a few and quits loading. Firing with a loaded clip works fine on nicd just loading mech

Edited by Codeman, 22 January 2019 - 12:29 PM.

  • 0

#2 Meaker VI

Meaker VI


  • Moderators
  • 1,190 posts
  • State:Washington
  • Country:United States
  • u/MeakerVI on Reddit

Posted 23 January 2019 - 12:10 PM

You might want to try isolating the loading circuit from the firing circuit and running the loader off the stock alkaline tray and the firing circuit off your pack. I know the loader is really fickle and touchy about its power, that could be an issue and hooking up the wrong pack might fry it.
  • 0

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users