Jump to content


Alphahawk prime

Nerf Accustrike

2 replies to this topic

#1 ENP10



  • Members
  • 49 posts
  • State:Tennessee
  • Country:United States

Posted 24 January 2017 - 06:43 PM

Is there any way to open the Alphahawk after attaching the priming bar?

  • 0

I Found some epoxy putty hidden in the basement and freaked out.

#2 Maniacal Coyote

Maniacal Coyote

    On Increasingly Thin Ice

  • Members
  • 358 posts
  • Location:Sacramento
  • State:California
  • Country:United States
  • u/Maniacal_coyote on Reddit

Posted 24 January 2017 - 06:52 PM

Pry it off with flat-head screwdrivers, like the Longshot bolt.

  • 0

I know how to help you because I have broken every rule in the book.

#3 Blasterthinktank



  • FNG1 
  • 1 posts

Posted 01 February 2017 - 02:19 AM

Best way in my opinion is to jam something hard and thin into the gap right above the priming handle. I used the flathead screwdriver on my leatherman tool. The tool will be pressing up the small tab that locks the handle, so you need to be wiggling the handle out while pressing the tool in. Be careful not to end up jabbing yourself in the hand like I did. With a little patience and some brute force the handles will come out. Once they're out, you can shave a little bit of the plastic off the handle and it will be removeable in the future much easier.

  • 0

Also tagged with one or more of these keywords: Nerf, Accustrike

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users