2 replies to this topic

[meltedspades]

Removal of clip and jam door locks, just cut the wires and short the 2 gray wires together (the red one should not be attached to anything)

wiring of the master power switch, wiring goes from batteries into switch and out to the red wire on the pcb in the first photo

Edited by meltedspades, 03 December 2015 - 12:16 PM.

[Remzak]

Can you post better pictures and explanations for the wiring to the master switch? Is it between the battery and the rev trigger? If so did you keep the rev to trigger lock?

[meltedspades]

Can you post better pictures and explanations for the wiring to the master switch? Is it between the battery and the rev trigger? If so did you keep the rev to trigger lock?

The switch is connected to red wire on the battery pack and red wire on the pcb.

Yes I did leave in the rev to trigger lock, no reason to leave them in.