Here is your stock Elite Alpha Trooper.
Obviously you need to unscrew the thing first.
Once you have done that, unscrew this part right here (the dart tooth securing piece).
Than remove this piece (the dart tooth)
Then slide the breach back all the way (it may help to remove the main spring first).
Then remove the muzzle piece.
removethis plastic crap (this is a lock that prevents you from priming the blaster until after you fire),
You can then proceed to remove the whole breach system and catch.
After you have done this, separate the plunger assembly and breach.
Start drilling out right here until you can see through the breach (don't have any pics of this but it is quite straightforward).
I have replaced both the main o-ring and breach seal o-ring with the those of the Retaliator because I thought the seal was not as good.
Now for the spring addition. Take the spring from the Retaliator and thread it aroud the stock spring.
In order to handle the new spring load you must also add on another catch spring.Use the one from the Retaliator.
Before you put evrything back in, remove this lock here.
You can now put everything back in where it belongs so it looks like this.
Screw it back together... NOTE: This blaster will not catch if you put the buttcap on. Leave this off!
And you're done! Money shot..
Angled: 30 degree angle
Q's? C's? F's?
Video coming soon!
Pj coming soon!
Edited by NerfOfSteel, 05 October 2013 - 07:22 PM.