Let's Get it Started...worst way to start ever.
Sandpaper or dremel sandbit
CPVC and CPVC T thing
E-Tape and Plumbers Goop
Hacksaw or Dremel Cutting bit
Of course the first thing your going to need to do is remove the air restrictors.
Next, you're going to cut right behind that nub type thing on the bolt.
Then, put the bolt in the T. Sanding may be necessary.
After this, put some kind of priming handle, usually a length of CPVC, on the T and plug it with either foam or an endcap,which I did not have accessible.
The last thing you're going to do is cut the dart tooth receptive thingy (Seen in the picture below) so it can receive the barrel, a length of at least 4 inch CPVC.
It should end up looking like this.
This performs on par with my singled longshot with a [k26] spring.
I believe this mod is capable of hitting ranges of 100' angled and if the wind isn't going the wrong way.
Edited by sharpshooter35, 25 July 2011 - 11:44 AM.