Jump to content


Photo

Dimensions Of At3k Tank


4 replies to this topic

#1 Jewstein

Jewstein

    Member

  • Members
  • 81 posts
  • Location:East Brunswick, NJ

Posted 16 January 2011 - 10:27 PM

Does anyone know the dimensions of the AT3K tank?
(Yes I searched with no success.)

Apologies if this question isn't topic worthy.

Thanks again.
  • 0
QUOTE

Most people don't use anything near that thick, so I am curious as to what you are up to? I'd offer to sell you some, but alas... I used all that I had when I upgraded the bullet proof glass on my pope-mobile.

#2 SlightlySane813

SlightlySane813

    Member

  • Members
  • 213 posts
  • Location:West CT/East PA
  • Country:United States

Posted 17 January 2011 - 12:06 PM

The length is 1 1/2 inches and the diameter is 1 1/4 inches without all of the attached auto rotation junk on it.

It also has a small flat side to it that is 3/4 inches.

If yoou plan on intergrating make sure you have some method of cutting off all the Auto rotate junk. :)
  • 0
Also known as the French Canadian eh!

#3 Jewstein

Jewstein

    Member

  • Members
  • 81 posts
  • Location:East Brunswick, NJ

Posted 17 January 2011 - 12:14 PM

The length is 1 1/2 inches and the diameter is 1 1/4 inches without all of the attached auto rotation junk on it.

It also has a small flat side to it that is 3/4 inches.

If yoou plan on intergrating make sure you have some method of cutting off all the Auto rotate junk. :)

Thank you so much.
Also, is there any writeup for that?
  • 0
QUOTE

Most people don't use anything near that thick, so I am curious as to what you are up to? I'd offer to sell you some, but alas... I used all that I had when I upgraded the bullet proof glass on my pope-mobile.

#4 utahnerf

utahnerf

    Member

  • Members
  • 339 posts
  • Location:Grosse Pointe Park, Michigan in summer; Aspen, CO for school.

Posted 17 January 2011 - 01:28 PM

To remove all of the rotation stuff, you could use a dremel, a scroll saw, a hacksaw, or go medieval on its ass with a knife. Really, you don't need a write up. Peace.
  • 0

#5 SlightlySane813

SlightlySane813

    Member

  • Members
  • 213 posts
  • Location:West CT/East PA
  • Country:United States

Posted 17 January 2011 - 03:18 PM

To remove all of the rotation stuff, you could use a dremel, a scroll saw, a hacksaw, or go medieval on its ass with a knife. Really, you don't need a write up. Peace.


Couldn't sum it up better myself.

Personally I cut off most of the stuff with wire clippers actually, then dremel.

Edited by SlightlySane813, 18 January 2011 - 11:19 AM.

  • 0
Also known as the French Canadian eh!


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users