Basically, it's a 2k with a SSPB pump mounted to a LSFG handle.
Pathetic Write-Up time!
First get your 2k tank and attach a piece of 1/4" ID vinyl tubing to the tank. Now get your SSPB and cut the pump off. I then took a piece of tubing from the hornet and attached it to the SSPB pump. Nest, slide the tubing from the pump into the vinyl tubing from the pump. Now glue on your PETG barrel (mine was 6 inches). It should look like this:
Now find a spare longshot jam door and cut a piece like so:
Now get your LSFG handle:
Glue the piece of the jam door to the side of the LSFG. (Note: If you are a lefty, glue everything on the oposite side. The gun in this thread is only for right handed people.) :
I don't have any pics of this next part (sorry), but it should be pretty self-explanatory. Take your 2k tank and turn it sideways. Glue it to the front of the handle and glue the firing pin to the trigger (it will take a LOT of fine tuning to get that to work right). Once you have accomplished that, bend the tubing and glue the pump to the piece of the longshot jam door. Finally, reinforce with epoxy putty. The resulting gun should look like this:
OK, now this part is VERY IMPORTANT!!! Do NOT pump until the OPRV valve kicks in. It does weird things to the internal o-ring and is very bad for the gun. ONLY PUMP 20-25 TIMES!!! I have found that this builds up as much pressure as a normal 2k (I think).
This mod was not very easy. In fact, it was a huge pain in the butt. I do feel that it is worth the effort though. It's a very fun blaster.
Questions? Comments? Suggestions? Flames (hopefully not)?
Edited by Abyss Mods, 11 December 2010 - 09:45 PM.