12 replies to this topic

[nerfer13]

Well here she is.

To do this mod you will need:

A double shot
Pliers
1/2 pvc
1/2 cpvc
Pvc cutter or a hacksaw
and finialy a mallet or a hammer.
(you will not need shells)

1.First you will need a double shot.

2. Now this is optional but if you want, take any type of saw and saw off the top or the barrel and make a sawed off shotgun

3.Take the little orange piece and the spring that Makes the shell eject, out with your pliers. (note this isn't the ejection spring, it is the normal spring I just couldn't find the ejection one

4. Now cut your pvc and cpvc 1 inch in length. (It has to be 1 inch)

5. Now hammer your cpvc in the pvc( this will be hard) until it looks like this (the inside of the black is the cpvc)

6. repeat this prosess again.

7 Insert your new shells into gun.

And now you have yourself a nice rear loading double shot

[mountain nerfer]

Nice mod, ranges?

[Capten Karat]

Why Can't the CPVC be longer?

[Captain Scottland]

I agree, it seems to me that the cpvc could be longer to increase some of the range.

Also, I was working on this exact type of mod, it's too bad you beat me to it now I have to find something else to do with this gun. Congratulations! it is a very clean mod.

[nerfer13]

Mountian nerfer- Ranges are about 55-65 feet flat.

Capten Karat- I did this mod a while back and I had 2 inch barrels. When I cut the barrels down it increased the range a lot. I think it's because the black whole on the stationary gun (the whole the air comes out of) is so small.

Captian Scotland- It seems like I beat you to it about 2 months ago ( I posted the write up on Nhq first). Theres always room for improvment so maybe thats where you come in.

[Wes7143]

I did this to mine, but couldn't get a good seal between the CPVC nested PVC and the air output. My ranges were around 35' in one barrel, and 25' with the other. I had 2" long barrels.

[Darken]

Well, I just tried this mod on my gun, but the darts don't even make it out of the CPVC. Do the darts need to be loose or something, because mine are nicely tight in CPVC, but maybe too tight.

[Collective]

There's a mod just like this in the directory, and no one seemed to be able to replicate it successfully due to seal problems. Although, I'd happily try this myself if my double shot wasn't hopelessly broken.

[Demon Lord]

Make sure the the CPVC sticks out from the PVC by about a 1/8 or an inch or so to ensure a good seal.

[Darken]

Make sure the the CPVC sticks out from the PVC by about a 1/8 or an inch or so to ensure a good seal.

Well I just tried that and it shot about 10 feet.

[nerfer13]

The darts need to be tight, but not too tight. Try sanding both ends of the cpvc, also try different weights for your stefans, for this mod the darts should be pretty light (try only hot glue).

[Renegademilitia15]

Hasn't this already been done before? Link.

[nerfer13]

I didn't notice that. After reading it I noticed that I did it a little differently than cole.

Edited by nerfer13, 31 May 2009 - 08:29 PM.