1) Take out all your screws. The screws in the cocking bar are different sized, so keep them separated. Here is what the internals look like.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo210.jpg)
2) Take out the turret.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo211.jpg)
3) Remove all screws from the back.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo212.jpg)
4) Take apart your turret, here is what it should look like.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo213.jpg)
5) Take these pieces out of the turret. The spring, and the three pronged disc. What is on the ground should be thrown away.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo214.jpg)
6) Now take these pieces out of the turret.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo215.jpg)
7) Use wire cutters to cut the prong. All you have left is the disc.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo216.jpg)
8) Use sandpaper to sand down what's left of the prong.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo217.jpg)
Here are your finished air restrictors.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo219.jpg)
9) Put your air restrictors back into the turret.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo226.jpg)
10) Take an ACE #49 spring and mark 1 inch from one end.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo220.jpg)
11) Cut the mark so the spring is 1 inch shorter. Here is the finished spring.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo221.jpg)
12) Now take these pieces out of the gun.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo222.jpg)
Here are the parts taken apart.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo223.jpg)
13) Take the old spring off. ( Keep it, it works wonders in mavericks.) Put the cut down #49 spring on. Here is a photo of the plunger rod with the new spring.
![Posted Image](http://i394.photobucket.com/albums/pp22/aceofnerf/Photo224.jpg)
Edited by ace of nerf, 27 May 2009 - 10:41 PM.