Dremel sanding wheel
6 pvc endcaps
9" of pvc
Jb weld two part epoxy
Ok here we go
1 Open up your hornet and take a good look at the intimidating internals.
2 take a sanding wheel and move it in a up and down motion on every blast chamber until theres a 3/4" hole in them.
3 now cut 6 1.5 inch segments of pvc.
4 smother one end of it in pvc cement and slap a cap on eveyone of them.
5 once your done with that take your sanding wheel and round the end of your pvc segments to match the curve of the blast chambers.
6 Now take your epoxy and litely dip the rounded end of pvc into the epoxy and stick it on a last chamber
7 Do step 6 to all the cambers and cut the shell so theres room for the extensions and your done.
you get props if you dont get frustrated during this mod
Edit- thanks imaseoulman for helping me understand how blast chambers work
Edited by nat, 03 January 2009 - 05:54 PM.