I purchased a PAS several days ago, and after my mods were done to it, I found that it was more difficult to close. I proceeded anyway. It all worked out until I saw a gap in the shell that needed to be tightened. I believe I screwed It too much, and therefore, I heard a "snap", and It could not even screw anymore. As a temporary solution, I plumbers-gooped it, closing the shell.
My question(s) is/are:
-What would be the est way to go about opening up the PAS again?
-What (if any) would be a possible solution to being able to tighten it again??
Pre-Thankage for any help Given!
A Quick Question
Started by Puppylayer, Dec 22 2008 01:29 PM
4 replies to this topic
#1
Puppylayer
-
- Members
- 130 posts
Member
Posted 22 December 2008 - 01:29 PM
QUOTE(nerfer9 @ Dec 26 2008, 01:34 PM) 
Coal? You're santa arent you! You didn't give me that bike I wanted! Prepare to die!
Also active as Slayer_of_OnE at NerfLovers!
#2
Foamfoot
-
- Members
- 461 posts
Member
Posted 22 December 2008 - 03:29 PM
Re-tightening it?: Larger screw
Opening it?: Firecracker (hacksaw will work fine, possibly dremel, but neither are nearly as cool.)
Opening it?: Firecracker (hacksaw will work fine, possibly dremel, but neither are nearly as cool.)
Edited by Foamfoot, 22 December 2008 - 03:30 PM.
Pro-pants
(Unofficial) Wii thread
Damn it Foamfoot. Why is it that you kill every good topic with a retarded response a few days late.
(Unofficial) Wii thread
QUOTE(Bedhed117 @ Aug 14 2009, 03:49 PM)
Damn it Foamfoot. Why is it that you kill every good topic with a retarded response a few days late.
#3
Puppylayer
-
- Members
- 130 posts
Member
Posted 22 December 2008 - 04:04 PM
Thank You for your suggestions...
Do you have any Ideas for what screw would work best for your suggestion?
Thank You.
Do you have any Ideas for what screw would work best for your suggestion?
Thank You.
QUOTE(nerfer9 @ Dec 26 2008, 01:34 PM)
Coal? You're santa arent you! You didn't give me that bike I wanted! Prepare to die!
Also active as Slayer_of_OnE at NerfLovers!
#4
laxtk88
-
- Members
- 189 posts
Member
Posted 22 December 2008 - 04:33 PM
I recommend that you get a long, thin screw that is slightly smaller than the diameter of the old hole. Just go to your local hardware store with the measurements in hand or even with the gun itself and get a few screws that you think would work.
QUOTE(Sleebo @ Jun 12 2008, 07:23 PM)
Just for the record, my mother is the most beautiful women in the world.
#5
Split
-
- Members
- 1,771 posts
Member
Posted 23 December 2008 - 04:04 PM
I think you mean slightly larger. I'd recommend a "wood screw". If the post actually broke off though, there's always the section on replacing them in my Crossbow guide.
Teehee.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
