Jump to content


Photo

A Quick Question


4 replies to this topic

#1 Puppylayer

Puppylayer

    Member

  • Members
  • 130 posts
  • Location:Naperville, IL

Posted 22 December 2008 - 01:29 PM

I purchased a PAS several days ago, and after my mods were done to it, I found that it was more difficult to close. I proceeded anyway. It all worked out until I saw a gap in the shell that needed to be tightened. I believe I screwed It too much, and therefore, I heard a "snap", and It could not even screw anymore. As a temporary solution, I plumbers-gooped it, closing the shell.

My question(s) is/are:

-What would be the est way to go about opening up the PAS again?

-What (if any) would be a possible solution to being able to tighten it again??

Pre-Thankage for any help Given!
  • 0
QUOTE(nerfer9 @ Dec 26 2008, 01:34 PM) View Post

Coal? You're santa arent you! You didn't give me that bike I wanted! Prepare to die!


Also active as Slayer_of_OnE at NerfLovers!

#2 Foamfoot

Foamfoot

    Member

  • Members
  • 461 posts
  • Location:Seattle, Washington

Posted 22 December 2008 - 03:29 PM

Re-tightening it?: Larger screw
Opening it?: Firecracker (hacksaw will work fine, possibly dremel, but neither are nearly as cool.)

Edited by Foamfoot, 22 December 2008 - 03:30 PM.

  • 0
Pro-pants
(Unofficial) Wii thread
QUOTE(Bedhed117 @ Aug 14 2009, 03:49 PM) View Post

Damn it Foamfoot. Why is it that you kill every good topic with a retarded response a few days late.


#3 Puppylayer

Puppylayer

    Member

  • Members
  • 130 posts
  • Location:Naperville, IL

Posted 22 December 2008 - 04:04 PM

Thank You for your suggestions...

Do you have any Ideas for what screw would work best for your suggestion?

Thank You.
  • 0
QUOTE(nerfer9 @ Dec 26 2008, 01:34 PM) View Post

Coal? You're santa arent you! You didn't give me that bike I wanted! Prepare to die!


Also active as Slayer_of_OnE at NerfLovers!

#4 laxtk88

laxtk88

    Member

  • Members
  • 189 posts
  • Location:Merrimack, New Hampshire
  • State:New Hampshire
  • Country:United States

Posted 22 December 2008 - 04:33 PM

I recommend that you get a long, thin screw that is slightly smaller than the diameter of the old hole. Just go to your local hardware store with the measurements in hand or even with the gun itself and get a few screws that you think would work.
  • 0
QUOTE(Sleebo @ Jun 12 2008, 07:23 PM) View Post

Just for the record, my mother is the most beautiful women in the world.

#5 Split

Split

    Member

  • Members
  • 1,771 posts
  • Location:Hammonton
  • State:New Jersey
  • Country:United States

Posted 23 December 2008 - 04:04 PM

I think you mean slightly larger. I'd recommend a "wood screw". If the post actually broke off though, there's always the section on replacing them in my Crossbow guide.
  • 0
Teehee.


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users