I searched around this site and noticed that there were no mos mentioning no shells on the rfr. This mod is not compatible with the clip unless shell is removed
o-ring that is same diameter as shell
Step. 1 take your rfr apart by removing the screws.
step. 2 clamp the shell in a vice or other device and cut about 3 millimeters off the bottom
step. 3 take the middle post/air restrictor out
step. 4 (optional) make the hole in the back of the 3mm high shell bigger
step. 5 take the large part of shell and o-ring gluing o-ring to cut part of shell and let dry
step. 6 once the shell is dry wrap the front of the shell, the bottleneck part in 1-2 layers of e-tape
step. 7 take shell and shove the e-taped end in the shell ejection
step. 8 put the gun back together
step. 9 (optional) take the 3mm piece of the shell once the dart is inserted in the back of shell and place it onto the o-ring. this piece adds about 5ft. of range
now your rfr is rear loaded, takes no shells and singled
you can pull the shell out of the shell ejection if you want to use the clip again
Questions? Comments. Flames.
Edited by erfig, 24 July 2009 - 01:44 PM.