![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/tribarrelss1-1.jpg)
Stuff you will need:
SS1
Dremel
12" of 17/32 brass
Pipe cutters
Goop
Super glue
A straw
Drill
5/32" drill bit
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/stuff.jpg)
Open it up.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/internals.jpg)
Take out this piece.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/barrelpiece.jpg)
Cut the old barrel off, and the rubber tube.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/cutit.jpg)
Drill into the empty spot with the 5/32" drill bit. Also drill into the spot where the secondary barrel used to be because the hole is a little smaller there.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/drillit.jpg)
Super glue 1/4-1/2" of your straw on the empty spot. This makes rebarreling it easier.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/straw.jpg)
Cut your brass into 4" pieces.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/barrels.jpg)
Goop the hell out of the orange piece then put your barrels on. Don't get any goop in the holes. I put a few drops of super glue down the middle of the barrels to hold them in place.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/glueit.jpg)
Cut the half of the SS1 shell where you need the barrel selector to go.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/thirdselector.jpg)
Dremel the inside so the barrels will fit. leave as much plastic as possible where the orange piece goes back in so that it stays in place.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/dremelit-1.jpg)
Add some hot glue to the front to stabilize the barrels and you're done. If you want to wrap e-tape around the plunger head then do so. If you can find a good spring replacement then use it. With a spring replacement mine gets 40-50' flat.
![Posted Image](http://i24.photobucket.com/albums/c19/oodalumps/tribarrelss1-1.jpg)
Edited by oodalumps, 10 October 2008 - 07:08 PM.