10 replies to this topic

[TimmyTown]

I was just wondering If anyone has succesfully constructed a brass breech (or other material) that accepts the longshot clips?

I searched and found nothing, and I searched google and stuff too. If there is such a thing I want to buy/build one.

[Magic]

An angel breech, I own the lancer which came with the angel breech. It's completely instructed by brass. Find out about it.

[nerfer9]

Angels wonderfully complex bunch of brassieness

Edited by nerfer9, 09 September 2008 - 06:54 PM.

[doubleshot]

I believe he means without using a longshot. There was one at one point, and I'm pretty sure whoever made it is still active. I searched but I couldn't find it.

[TimmyTown]

I believe he means without using a longshot. There was one at one point, and I'm pretty sure whoever made it is still active. I searched but I couldn't find it.

Yes I do. I think it could be constructed as any other breech and just use some brass that can slide over the dart inside of the "prongs" on the LS clip slide through. It could be a bit complex but I think it could be achievable.

[slowguitarman]

Yes, there was a homemade breech that could accept ls mags. Here is one, and there is another, but I can't find it, and I don't remember who made it.

[CaptainSlug]

http://nerfhaven.com...pic=9706&st=120

[Nova]

http://nerfhaven.com...pic=9706&st=120

Uhh... wow. I think Resident Mad scientist is an appropriate term.

But i can't imagine that being war-legal, it looks like a homemade real gun. Plus its pneumatic.
No longer Nerf, but foam blasting machined weaponry!

ViVa Nerf Revolution!

umm.. yeah,

Nova

[rork]

The APB5K is absolutely war-appropriate; some of the most exciting work that is currently being done with nerf guns is being done in the field of HPA tanks, actuated rams, and so forth.

On topic: http://nerfhaven.com...opic=10860&st=0

Edited by rork, 09 September 2008 - 08:18 PM.

[Mepain]

Here's another one, though it was apparently scrapped due to bad seal, etc.

[imaseoulman]

I don't remember the link, but I believe it was a spectre's arms product, but there is a very simple breach that can be constructed to accept LS clips out of PVC and PETG. Simply cut a spot in the PVC about the length of your darts. Then proceed to sand away (or cut or however you want to remove) the PVC around the hole you just cut until it's small enough for the LS clip to snap onto the PETG (that will slide through the PVC) and PVC. Then just add a handle to the PETG and you have your clip.

So, to sum it up, make a PETG breach in PVC. Then just make sure you can clip on a LS clip to it. Done deal. Not perfect but it works and is fairly easy.