Jump to content


Photo

Homemade Darts?

I have aproblem with some.

6 replies to this topic

#1 Zekk

Zekk

    Member

  • Members
  • 16 posts

Posted 12 February 2003 - 07:15 PM

I have some guns with a pin with an airhole in them how do you make darts that fit them?
  • 0

#2 WebbZter

WebbZter

    Member

  • Members
  • 56 posts

Posted 12 February 2003 - 09:01 PM

You have three choices that I know of:

1) Saw off the barrel and replace it with a piece of PVC pipe (you'll also see an increase in range)

2) Twist the pin off using a pair of needle-nosed pliers

3) Burn a hole into the back of the darts by putting a Wendy's straw to the back and twisting it really quickly. The Wendy's straw will "drill" into the dart

Tell us what guns they are so we can give you specific instructions.
  • 0

#3 Spoon

Spoon

    Meh.

  • Founders
  • 560 posts

Posted 12 February 2003 - 09:01 PM

You don't. You get a pair of pliers and rip the pin out.
  • 0
Two roads converged in the woods, and I took the one less traveled......and now I don't know where the hell I am.

#4 SniperWolf

SniperWolf

    Member

  • Members
  • 103 posts

Posted 12 February 2003 - 11:47 PM

I take a sharp pencil, stick it through the dart and heat up the foam with a blowdryer. Then, after the stefan-to-be is soft and bendable, you plunge it into ice water, with the pencil still in it. Take it out about 5 minutes later and presto! A stefan with a hole in it!
  • 0
My children...They beat me...

...with sticks and buckets.

My wife...she is hairy...

...like sasquatch.

#5 Zekk

Zekk

    Member

  • Members
  • 16 posts

Posted 03 March 2003 - 04:31 PM

Thanks for the ideas. I thing i can figure something out now.
  • 0

#6 Puddle of Foam

Puddle of Foam

    Member

  • Members
  • 132 posts

Posted 04 March 2003 - 05:16 PM

You don't. You get a pair of pliers and rip the pin out.

Um, have you tried that on a Splitfire? It ruins the gun. Webb was right, you twist it out.
  • 0
Do you have the papers...?
No, but I have a big [BLEEP] gun. That's good enough for me!
-Fallout 2

If anyone was wondering, I'm RoboNerfer from NO. And I'm U.n.c.u.T.! on NerfHQ.

#7 cxwq

cxwq

    Member

  • Founders
  • 3,634 posts

Posted 04 March 2003 - 06:16 PM

You don't.  You get a pair of pliers and rip the pin out.

Um, have you tried that on a Splitfire? It ruins the gun. Webb was right, you twist it out.

You disassemble the gun until you can nicely remove all the offending crap at the base of your barrels. This usually involves sawing the barrels off but you were going to do that anyway so you can replace them with something better.
  • 0
<meta name="cxwq" content="mostly water">


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users