Jump to content


vaan

Member Since 20 Feb 2007
Offline Last Active Nov 19 2018 10:21 PM

Posts I've Made

In Topic: Screw Ports - How to reconnect?

08 May 2017 - 05:55 PM

Usually the best thing to do is fill it with putty, and a small layer around it, after it cures, drill a pilot hole into it, and screw it together. You could also solvent weld the plastic together, if you have the tools, work area, and patience.

In Topic: Nerf supermaxx 5000 tank leaking. Solutions or at2k tank?

06 May 2017 - 03:53 PM

All adding that valve is doing, is only allowing air to flow one way, from the pump to the tank, so that way it doesn't flow pack out the pump. It has little to do with the over pressure release valve in the pump.

In Topic: Nerf Vulcan Modification (Help)

06 May 2017 - 03:50 PM

Use boiling water. Dip it in for a second or two and then tap it with a hammer. It should come off if it's glued.

In Topic: slugs and breech help

01 May 2017 - 02:14 PM

http://nerfhaven.com...ade-nerf-darts/

In Topic: Nerf longshot help

29 April 2017 - 04:06 PM

So, if that's the case you should pad the plunger head with rubber/ foam and use a longer screw ( depending on the size of the existing screw ) to hold the plunger head to the plunger rod. People put foam inside the blaster to dampen the sound of the plastic echoing since you've removed the air restrictor. It isn't necessary, and I haven't used the method much to let you know how well it works.