- NerfHaven
- → Viewing Profile: Posts: Jpec07
Jpec07
Member Since 26 Mar 2009Offline Last Active Mar 23 2010 12:50 AM
Community Stats
- Group Members
- Active Posts 20
- Profile Views 3,127
- Member Title Member
- Age 36 years old
- Birthday April 3, 1988
User Tools
Latest Visitors
No latest visitors to show
Posts I've Made
In Topic: Custom Foam Job (requests)
10 November 2009 - 06:05 PM
Perhaps I'm missing something, but would this foam be available to Nerfers outside of Australia? I mean shipping would be relatively cheap (it's foam), but I'm curious to know if it would even be possible...
In Topic: Stefan Question
10 November 2009 - 05:49 PM
(I assume you are using hardware store foam.
Yes. I was unaware there were different grades of foam available for purchase. If I may ask, what's the best place to get denser dart foam? We got ours from Lowe's (none at the Ace Hardware in San Dimas)--and it is rather flimsy and doesn't want to stay straight (even after trying a few of the methods listed in the sticky thread).
In Topic: Stefan Question
09 November 2009 - 11:57 PM
That...does seem like a good idea. Only problem is that the glue gun I got doesn't have high and low settings (then again, it was only $3, so I can't complain). Should I invest in a new, better gun, or is there another workaround?
In Topic: Suggestion: Thread Necromancy Control
06 November 2009 - 12:15 PM
So the warning message is out, because its ineffectiveness is evident. What about auto-close? So far as I can tell, there is no practical benefit to keeping threads like that open. If the only argument against it is that it's a little bit harder to implement than I'd thought (though certainly easier than the warning message), dare I suggest you all in the moderation give it a shot?
Also, a problem isn't worth complaining about unless you're going to take steps towards a solution; if you're unwilling to try and fix it, then you're just making noise for the sake of making noise.
Also, a problem isn't worth complaining about unless you're going to take steps towards a solution; if you're unwilling to try and fix it, then you're just making noise for the sake of making noise.
In Topic: Question Awnsered
12 October 2009 - 05:03 PM
If I remember right, it was a question about BBB replacement springs. Though I may be mistaken. Probably am.
Either way, I took the initiative to send the guy a PM asking him to put the question back in, and explaining to him why you don't get rid of the question once it's been answered (it's common netiquette). No need to get on his case in-thread when the issue can be resolved with a PM.
Either way, I took the initiative to send the guy a PM asking him to put the question back in, and explaining to him why you don't get rid of the question once it's been answered (it's common netiquette). No need to get on his case in-thread when the issue can be resolved with a PM.
- NerfHaven
- → Viewing Profile: Posts: Jpec07
- Terms of Service and Privacy Policy
- Code of Conduct ·