I've had this gun for a while now, and I remember seeing some super soaker nerf mods, but I can't find anything specific about this gun. I really don't know much about the design of super soakers, can someone explain how I would go about turning it into a nerf gun? I'll get some internal pics up if necessary.
I went into ACE today and picked up a couple of lengths of brass, some NF sized springs, and about 6 O-Rings. The O-Rings I bought were four 1" sized (NF) and two 1 3/8" sized (LS). The LS O-Ring fits perfectly, but the ones I bought for my NF are just a little too thick. The plunger cap cannot fit down the pressure chamber. Would you suggest I sand down the rings with a dremel or what? It may be some time before I can get back to ACE to get some thinner ones, so a more immediate substitute is my priority. Thanks for any help you can give me.
I'm not sure if this is the right board to post this on, sorry if it's not.
I was using my dremel to add a sling to my longshot about 10 minutes ago. I had one of those circular cutting discs on, and right when I touched it to the plastic, the disc shattered and flew away before embedding itself in a wall.
First of all, I was scared to death. I almost lost an eye, finger, hair, etc. That thing went an inch past my face. My hands are shaking while I'm typing, so I'm glad I can spellcheck this. Almost the entire disc was broken except for a small shard which continued to spin creating a cool invisible dremel tool look. That was about where the coolness ended. This has never happened to me in all of my 4 week's experience with a dremel. The bit was secured to its little holder thing with a small flathead screw. I've used these bits before and this has never happened. Why? I'm probably not going to use my dremel before this board is destroyed and everyone is dead. Please help!