I had some cpvc scraps lying around, and then I saw my longstrike and one thing led to another. Sorry for the post mod pictures, I didn't think about it until I decided to do the write-up.
Let's Get it Started...worst way to start ever.
Materials Needed:
Longstrike
Screwdrivers
Sandpaper or dremel sandbit
CPVC and CPVC T thing
E-Tape and Plumbers Goop
Hacksaw or Dremel Cutting bit
Of course the first thing your going to need to do is remove the air restrictors.
Next, you're going to cut right behind that nub type thing on the bolt.
http://www.flickr.co...in/photostream/
Then, put the bolt in the T. Sanding may be necessary.
http://www.flickr.co...in/photostream/
After this, put some kind of priming handle, usually a length of CPVC, on the T and plug it with either foam or an endcap,which I did not have accessible.
http://www.flickr.co...in/photostream/
The last thing you're going to do is cut the dart tooth receptive thingy (Seen in the picture below) so it can receive the barrel, a length of at least 4 inch CPVC.
It should end up looking like this.
http://www.flickr.co...in/photostream/
Finished Product
http://www.flickr.co...in/photostream/
This performs on par with my singled longshot with a [k26] spring.
Happy Modding!
Ranges:
41'
43'
53'
57'
63'
69'(hehe)
I believe this mod is capable of hitting ranges of 100' angled and if the wind isn't going the wrong way.
sharpshooter35
Member Since 09 Jan 2009Offline Last Active Mar 31 2012 10:51 PM