Jump to content


The Shadow

Member Since 03 May 2006
Offline Last Active Mar 02 2008 08:50 PM

Posts I've Made

In Topic: Nyc Area Sites/wars

24 February 2008 - 07:52 PM

Wars aren't common in the city, they're usually hosted in the towns with parks and open woods.

In Topic: Life Without A Dremel?

23 February 2008 - 04:51 PM

This is correct. I don't even own a rotary tool anymore. I can accomplish the same tasks with wire cutters, hand files, X-acto knives, and if needed some stone grinding bits in my drill press.
I'm of the opinion that dremels are just not very cost effective and make simple tasks more time-consuming and hazardous than they need to be. Plastics should be cut with sharped toothed blades, not abrasive cutting bits or sanding drums.

For everything else there's the scroll saw. Out of all of the tools I have access to I probably use it the most.


I understand your point but, I speak for myself when I say this, I know that I can't afford a drill press and if i could I definatly would've taken it over a dremel. I think that its a good tool to have for doing a lot of basic mods. If your doing heavy-duty homemade mods or even mods to guns, it is better to have some better equipment.

In Topic: At3k Problem

23 February 2008 - 02:47 PM

Check for leaks, or you could make a bigger tank (PVC with a PVC end-cap).

In Topic: Rf 20

22 February 2008 - 10:42 PM

So, you basically made a topic about how your going to get a gun?

In Topic: Big Blast W/mav Turret

22 February 2008 - 01:31 PM

Ranges are about the same as a normally modded big blast