Jump to content


Silas4lagoon

Member Since 17 Jun 2019
Offline Last Active Jul 06 2019 04:34 PM

Topics I've Started

Powerful Nerf Double action Pistol

05 July 2019 - 01:22 PM

Here is my second concept so far, and it is a very cool one. It's a Double action Nerf Pistol, based on the M1911, which can use either stefans, or rival ammo.

 

This is a rough layout of the mechanics, but it's still very simple. The entire system can be seen in Fig. 8 and 9. It uses the same mechanism as in a Automatic center punch, A tool used in metalwork (fig 6). This works by having a block under spring tension, so that the plunger cannot move. When the block is moved in line with the plunger, it fires the whole mechanism. This allows for more powerful springs, and therefore, more power behind the dart. The system can be cocked either by a trigger pull, or by pulling back on the lower nobs as seen on the bottom of the plunger cylinder. Loading is done by having the barrel move back and forth. 

 

Currently, I am working on adding a Saftey, Hammer, magazine port, and other features. 

 

Again, this is still a work in progress, but if there are any suggestions, and/or critiques, please leave them down below.


Nerf M-1 Garand concept

28 June 2019 - 07:05 PM

Ok, So while this is my first attempt at something on this level, I think I have a good idea, so tell me in anything which could be improved upon. I will be attempting to build it this summer, just for reference. Anyway, here is a basic overview of how it would work, because it is fairly complex. (note that as of the time of this post, I have already made and tested a lego model of the clip system, and it works with very few kinks, except nerf darts being too long.) 

 

 

 

First let's start with the Magazine assembly (fifth picture). It has three main parts (as shown in the first picture). These are the Follower (top), Main rod (middle), and ejection lock (bottom). The follower acts like with any other En Bloc, moving the darts up. The Follower is being powered by a spring under the main rod. the clip itself has groves which allow the follower to use it as a track. Anyway, when the follower moves up, It rotates the Main rod, due to connecting rods. This in turn moves the ejection lock, which releases the clip ejector when the follower is at max height. This is accomplished by the use of groves cut into the side of the ejector, like Lincoln logs, that hold it in place until the clip is empty.

 

 

The other major part is gas piston (Shown with its various parts in pictures 2, 3, and 4. It is essentially a single acting Pneumatic cylinder with a built in quick release valve. This means that it is a pneumatic piston, with a spring return, and a button to release all the air down the barrel. This works by having the pressurized air push the the bolt, with quick release, into place. The trigger just sits in the grove until the bolt is closed. when the trigger is puled back, it unlocks the seal on the valve, and all the air used to move the piston is used to move the dart down the barrel at high speed. the spring then returns the bolt to its original place, letting the next dart move up, and reseting the whole system.