Find content
Greetings,
I recently have been learning about and using short darts, and I would like to modify my tri-strike (which has my 3D printed pump action kit - link at bottom) so it shoots half darts. I know this has to do with changing the length of the breech, but is there any guide where the internals are close enough to the tri strike which I could follow? (I don't think the retaliator is close enough) If not, I would appreciate it much if you have experience in this area to help.
Thanks!
https://www.thingive...m/thing:3514857
FYI I'm new(ish) to the hobby.
Tbot100
Member Since 05 Jun 2019Offline Last Active Jun 06 2019 08:33 AM
