- NerfHaven
- → Viewing Profile: Posts: Kilomona
Kilomona
Member Since 22 Nov 2015Offline Last Active Apr 10 2023 08:10 AM
Community Stats
- Group Members
- Active Posts 108
- Profile Views 4,835
- Member Title Member
- Age Age Unknown
- Birthday Birthday Unknown
Posts I've Made
In Topic: 95 Crossbow Clip Fed?
28 February 2017 - 03:42 PM
Similar to how the koosh vortex tornado used a priming handle that pulls the rod back, but isn't attached so it can for forward again could we put a long notch on the priming rod?
In Topic: S.O.S. Endangered Shell Protection Initiative
20 February 2017 - 03:09 PM
The idea of this thread is what we're working on over in the "koosh vortex tornado scans (now a shell replication thread)" thread.
In Topic: Can everyone please mesure their nerf guns?
16 February 2017 - 08:16 AM
Sure, once I'm home on Friday/Saturday. Will upload data in centimeters and inches. Might be off by a little bit because I don't have calipers, so I'm using a tape measure.
In Topic: Koosh Vortex Tornado Scans (Now a shell replica concept thread)
06 February 2017 - 08:26 PM
DON'T QUOTE THE PICTURES IF THEY'RE IN THE POST IMMEDIATELY ABOVE YOU, YOU DUMMY.
- ICE NINE
That is niiiice. Is it 3D printed? And do you have internals to put into it to test the strength? I don't think it won't matter as much for the tornado, as the internal parts take most of the stress, but it would be nice to see some good progress.
In Topic: Koosh Vortex Tornado Scans (Now a shell replica concept thread)
31 January 2017 - 05:23 PM
As for the aluminum casting, what about modeling shells in foam? We could experiment with small, less detailed shells like the SSPB, or print shells in flammable filaments ( if such a thing exists).
- NerfHaven
- → Viewing Profile: Posts: Kilomona
- Terms of Service and Privacy Policy
- Code of Conduct ·