Hey everyone, I'm looking to replace the internals in my longstrike, and I'm hoping for some more power will durability. My longstrike is currently modded as follows: AR Removal (though this did screw up the breech a bit, but it seems to work fine), and Spring compression (stock spring). I use stock elite darts currently with it. So my questions are what do you think I should do? I'm trying to squeeze as much power as I can out of this blaster. Are replaced internals going to help? I was looking at the OMW Immortal kit (though I currently can't order it) or the Xplorer Full Length Dart kit (though this is kinda expensive, especially with S&H). Are they needed? Can I get the power I want from just more moding? Are there other options?
I'm completely lost. I play HvZ at my school, and have modded my blasters to the point where stock darts just don't make the cut anymore. I'm currently getting by with strawing Elite dart, however I figure making my own darts is a better long term solution. I've done some research and am a bit lost. I found Xplorer, and saw that they have premade dart tips and precut foam for sale that looked good, but since it ships from Singapore and I live it the US, the cost for shipping looks to be more than I am willing to spend. What are my options? Should I look for more "Premade" tips and foam, or should I make my darts by hand?
Ideally I'd like them to fit into an unmoddified clip and load properly, and be accurate at short and long distances. Any help would be greatly appreciated, thank you!
Find content
