Jump to content


Member Since 18 May 2011
Offline Last Active Sep 05 2011 09:11 AM

Topics I've Started

Valve Help

04 September 2011 - 04:21 PM


(Thanks, roboman)

I'm having trouble with the grommet's seal on the valve I'm making. I epoxied it into place and the seal will hold up to 20 psi. After that, it leaks from the area between the standoff and the ID of the grommet. How can I fix this? I'm out of delrin so I hope to fix this without having to remachine the whole thing. Perhaps the trouble is because I made this on a drill press instead of a lathe, possibly causing a slight misalignment.