Can someone give me the dimensions of an At2k airtank? I am going to integrate it into my EaB.
At2k Airtank
Started by Vassili, Jan 29 2003 01:07 PM
3 replies to this topic
#2
Posted 29 January 2003 - 01:47 PM
I don't have my AT2k handy but out of curiosity, will this be in addition to the plunger or replace it?
<meta name="cxwq" content="mostly water">
#3
Posted 29 January 2003 - 03:17 PM
I believe he is planning to integrate it below the main barrel. I'm unsure of the dimensions, but it's going to take a lot of work. It will have to be placed towards the rear below the barrel, and you will probably have to cut away much of the underside and remove the black handle. I have no idea where you would put a trigger. You could use the original one if you placed the pump under it and attached a shorter tube to it. That might be the best option.
"The occasional hell or damn is ok,
but we do sh*t and F---"
~Webbster, Foam Improvement.
"I got four points... I sackled you"
but we do sh*t and F---"
~Webbster, Foam Improvement.
"I got four points... I sackled you"
#4
Posted 29 January 2003 - 06:49 PM
Yes it's in addition to the plunger. I stayed home sick today so I emptied out the insides below the barrel. It should fit but I have to sacrifice one srew hole. I also put in probably the same spring as Cxwq's EaB, it's a lot more accurate than the stock springs with bands.
Foam Fortress Co-Webmaster
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users