11 replies to this topic

[Dangaard]

My plan is to keep the LS bolt/clip parts, but I want to add an at2k like this



my plan is to epoxy a lexan sheet ontop of the trigger in order to do so it will have to be placed back far enough not to interfere with the bolt asembly.


I will then Attach a bit of steel cable (braded) to the lexan plate and the at2k firing pin. the wire will have enough slack so that the at2k cannot be fired untill it is in the forward position.


I am going to have to grind down some of the inner walls to make room for the lexan.



I have circled the inner walls I will have to grind down



So, any advice you would like to give?

Edited by Dangaard, 18 July 2007 - 07:12 PM.

[nerfer909]

I would just say go for it, it sounds like it would work.

[chalywong]

Where is the pump going to go?

[Dangaard]

On the outside, if you were holding the gun in your right hand it would be on the left side.

[Prometheus]

It`s cool and all, but alot of the vets around here, ask why as it lowers your ROF. Perhaps there is something else here that you are trying to accomplish here...

[Dangaard]

Yeah, it lowers overall Rof, but I removed the dart tooth before I knew what I was doing. I replaced the at2k pump with a larger pump to now its only 1-2 pumps for power. I hope to increase my ranges without having to somehow manufacture a breech.

Edited by Dangaard, 19 July 2007 - 09:20 AM.

[Prometheus]

You`ll need to replace the barrel to get better ranges. More power and a shitty barrel will do little. Also, a better barrel will really increase accuracy, as well as effective utilization of air.

[Dangaard]

I believe I neglected to mention and it's not in the pics but I did replace the barrel with a loose copper barrel, but its not to loose. The rebarreling is why I replaced the dart tooth mechanism. ah the irony.

[monkey with a nf]

It looks like you have the AT2K tank resting on the bolt carrier, which would be a good way to keep it sealed, but I'm wondering how that will work with the trigger.

[Quilan Fett]

You should make it so it pumps as tou pull the bolt like the LS/AT3K.

[Dangaard]

Qui'lan, I have thought about it but I descided not to, mabey after I find a small pump that fills the at2k in one pump with a stroke 5" long, not likely.

[blister]

You could always make a pump.