#1
Posted 26 January 2003 - 11:13 AM
#2
Posted 18 February 2003 - 11:32 AM
What I did was do the normal glueing of the valve... It's been a while, but all I remember was it took me about two hours to actually take it apart. Just be careful with the internals if you open it up (which you wouldn't be) because the stupid springy thingy always comes out...
For a barrel mod, you cut the barrel off about three inches (I'm pretty sure, check on Sniper5k's site just in case) and stick in a PVC pipe, there's your megas.
For minis if you want, just put a piece of brass inside the PVC.
~Mystic~
#3
Posted 18 February 2003 - 11:39 AM
but we do sh*t and F---"
~Webbster, Foam Improvement.
"I got four points... I sackled you"
#4
Posted 18 February 2003 - 12:36 PM
~Mystic~
#5
Posted 18 February 2003 - 06:27 PM
#6
Posted 18 February 2003 - 07:22 PM
#7
Posted 18 February 2003 - 07:53 PM
~Mystic~
#8
Posted 19 February 2003 - 04:42 PM
#9
Posted 24 February 2003 - 01:36 PM
~Mystic~
#10
Posted 24 February 2003 - 02:34 PM
K:H=1.00
Shots Fired: 2.1 x 10^4
Fun had: 97%
#11
Posted 25 February 2003 - 09:15 PM
#12
Posted 28 February 2003 - 04:17 PM
Ughh... Too bad none of the old good sites for mods are up... I'll see and try to put up the sm500 mod on Foamland.
~Mystic~
#13
Posted 28 February 2003 - 04:21 PM
#14
Posted 28 February 2003 - 05:08 PM
#15
Posted 28 February 2003 - 05:53 PM
#16
Posted 28 February 2003 - 06:43 PM
...It looks like you should be able to stick a piece of PVc loosely... That's how its supposed to be...
The air restrictor is the same as the normal SM500...
The third pic doesn't look like anything...
What exactly is the problem? It all looks like the piece of PVC could fit, is it not fitting?
~Mystic~
#17
Posted 28 February 2003 - 08:21 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users