Here is what ye shall be constructing:
Hacksaw (or PVC pipe cutters)
1/2" CPVC pipe
3/4" PVC pipe
1 3/4" PVC coupler
Big Bad Bow
Hotglue and gun.
Ok, so step number one: You have to dremel out one side of the 3/4" PVC coupler until two pieces of CPVC can fit inside of it. DO NOT DREMEL OUT THE OTHER SIDE!!!!!!
Oops! I forgot to say, you have to cut two barrels out of CPVC, mine were about 3.5" long. Then, hotglue the two barrels together, and make sure they are about the same length.
Take your newly glued barrels and get them into the coupler (use a hammer if you need to), and take out some of that FBR, and cut out two pieces bout an inch long.
Take these pieces of FBR and stuff them in the holes next to the barrels.
End of part 1
Edited by Chewbacca, 18 June 2007 - 06:40 PM.