8” of ˝” SCH. 80 PVC
Krazy glue or some type of adhesive, other than hot glue
Optional: 17/32” brass, stronger spring or Rubber bands
Saw or Dremel
Open it up (sorry no picture of the innards, but you can check out thismod for some)
Then take that 8” of PVC and cut it into 2 pieces of 4”. Then take the stock barrels and cut then down to just the pieces that connect to the green barrel switcher. Glue the PVC and the little stock barrel nubs together and wrap some e-tape around the connection.
Glue everthing together to make sure there is no air loss.
Now wrap the plunger head in some e-tape to get a good seal.
There you go. You can be done there or you can continue by cutting 4” of 17/32” brass and dropping those into the sch. 80 PVC.
There you go. Slap on some bands or a bungee, or a new spring and you’ve got yourself quite a pistol.
Edited by sam, 07 January 2007 - 03:26 PM.