Ok first thing to do:
Remove all the screws, and seperate the 2 halves
Then remove the entire breech (group of barrels) and the hinging mechanism from the gun
Next take a screwdriver or a punch and punch out the metal rod that goes down the center of the breech
The rod is normally has 2 plastic round plugs, thats what u punch the rod out of
After u have the rod, with 1 plastic plug on one end, then u are going to sut that rod off, about 1 inch from the end
After that et the rod aside
This is what the rod should look like, i will get to the placement of it later
The next thing u do is remove the 3 screws on the back of the breech
Then seperate the back part of the breech
U should see 2 very small silver screws that connect to the orange plastic thing
U want to remove the 2 screwes, then remove the grey hinge and replace the screws
This is what the finished breech should look like
Next u need to seperate the 2 half of the gun
And remove the spring, plunger, and trigger mechanism
U remove this so when ur cutting it, it wont get in the way
Then put the 2 half back together, with no screws inplace
Now u need to cut the top of the plastic as shown
I left quite a bit of gap for the velcro to go
Next u wanna remove the 2 halfs
And on the left hand side, u wanna cut as shown
Now on the right hand side, cut as shown
Now u want to drill out the left hand side screw hole, not too big thou
Just enough for the screw to go in and be able to turn
U do this so when u screw the sides back on, the gun actually hinges on that screw
I hope i have been clear, if u have any questions or need more detailed pics, let me know
Im seling the mavericks, $25 shipped, i have 2
Im also selling a brass barreled NF
http://cgi.ebay.com/...19756&rd=1&rd=1
Also im selling a modded and painted longshot
http://cgi.ebay.com/...36680&rd=1&rd=1
Also i have modded several NF's
heres 1:
Edited by Bob3104558, 21 October 2006 - 10:12 PM.