7 replies to this topic

[l337n3rf3r]

I made Unknown's basic breech yesterdy. i Used 1" PVC and 1/2'" PVC. I decided to modify it further and made it clip/magazine compatable. would i need to make a seal for slide back over the covering before firing?

Edited by l337n3rf3r, 04 October 2006 - 04:54 PM.

[Carbon]

would i need to make a seal for slide back over the covering before firing?

I'm not exactly sure what you mean. But generally, a mag is just a box that's sitting over your breech cutout. Since you made your seal when you made the breech, there's shouldn't be any additional seal needed.

[l337n3rf3r]

I'm not sure what you mean. I'm not sliding the 1/2"PVC forward. Im leaving it where it is.

[Stormleader]

This is going to sound stupid, But I have searched and found nothing so I am wondering could someone gave me a link the Unknown's breach?Thanks. And on topic I think you have to slide the PVC over it.







Storm

[Carbon]

I'm not sure what you mean. I'm not sliding the 1/2"PVC forward. Im leaving it where it is.

In that case, you need to describe what you're doing a bit more, or post pictures. The typical Unknwon breech setup has the barrel (.5" PVC) sliding forward, and the 1" stays put.

This is going to sound stupid, But I have searched and found nothing so I am wondering could someone gave me a link the Unknown's breach?Thanks.

http://nerfhaven.com...zero_ballvalve/

The illustration of Unknown's breech is at the bottom.

[Stormleader]

Thanks Carbon!

[Nerfnewbie]

Not to get off topic but I didnt want to start a new one. Does anyone know if there's a different way to cut the "hole" for the dart to go in for a breech other than using a dremmal? Sorry about the spelling errors...tired.

[mav3r1c]

You could use one of the hole cutting bits for a drill.