6 replies to this topic

[Arcanum]

This should eliminate all magazine problems without having to cut down the spring.

Hence, you will have a stronger weapon (granted it will be harder to cock) and your clip will slide in and out as smooth as ever.

[meiser5]

If you put enverything back together right you should not need to do that to your clip, but that is a great idea to fall back on if your gun still won't take the clip... Good job.

Meiser

[Lancaster]

What did you use to make the cut, a dremel? I might do this because my magazines are refusing to fit in the gun...

[One Man Clan]

I had to do something similar to mine. The Maxshot spring pushed the plunger too far forward and was hitting the clip.

[Arcanum]

Don't own a dremel


So I just hack sawed it very carefully.

Dremel should work fine.

[NerfMonkey]

If you put enverything back together right you should not need to do that to your clip, but that is a great idea to fall back on if your gun still won't take the clip... Good job.

Meiser

I have this problem right now and everything's back in just as it was stock, minus the restrictor. The new spring fucks up the loading somehow and you have to shove the clip in hard at the right angle so it will fit in. I can post a video if you want.

[CaptainSlug]

I only had to sand down the rear of a clip a tiny bit, but then again I did choose a spring that has a compressed length similar to the stock spring.