4 replies to this topic

[Uncle Hammer]

Well folks I butchered my ss1 trying to tri-barrel it but it wasn't gonna give up on it that easy. A nf plunger is very similar in size to the original ss1 one. So basically I stuck a NF plunger tube with the ss1 spring and catch into the case(with a bit of some gridning and sanding, actually a lot). I then attatched a small piece of cpvc to the plunger tube and then attached a cpvc coupler to that. The 2k turret has 4, 1 1/2" inch cpvc barrels attatched to the turret. It then has a small piece of cpvc taht connects into the coupler. I could have had a removable turret but it would have mad the gun look awkward beacause I would have needed a larger peice of cpvc from the turret to avoid hitting the turrets roatating mechanism. All in all it turned out well, I'm getting ranges of about 40-50 ft, which isn't bad for a pistol with 4 shots on it. I have pics below and then a video firing 4 shots. Enjoy!







Video

[JSkater]

That's... Interesting! Nice job.

[Forsaken angel24]

Can you bring the turret closer to the gun. It looks like there is some extra space in between. The cpvc that connects them looks too long. This would make the gun look smaller and aid in slightly better ranges.

I just like the fact that there are the peices to 3 different guns in one. This is why I never throw anything out when it comes to Nerf parts/springs/shells etc.

[Master Yogurt]

What's the point of the coupler if the turret is non-removable? I'd attach the cpvc the turret is sitting on directly onto the plunger tube and move the turret itself closer, which would increase the gun's range a good bit.

[Uncle Hammer]

I actually was pondering the same thing today. I thought it looked abit goofy with the coupler on. The coupler was actually a last minute mind change I had. I just finished taking it off and re-applying the turret to the plunger tube. I'll get some pics up tommorow.