I plan to cut a hole about 3/4ths of the way down the barrel on the top only, to allow my micro dart ammo to fall in. I am going to be using a 5 round ammo magazine, which will be permanently in place, it will be gravity fed, hence why the magazine is loaded from the top, much like a Bren. I plan to have the magazine made out of a sturdy kind of wood, probably oak, the top rectangular piece of the magazine will have either a door, or a sliding panel, allowing me to drop more ammunition in as necessary.
It will be using a ball valve, for simplicities sake, and the only thing that I might have problems with is I plan to integrate an entire bicycle pump into the rifle. Which with extra tubing made out of PETG will reach up to where I plan to have the air tank, the PETG will be cinched and duck taped, if I am not able to have what I believe to be a good enough sizing with the end of the bike pump.
The PVC you see going down and reaching the bike pump after the Ball Valve is simply a foregrip.
Well, here she is, I hope that my write up wasn't too rough, or my paint drawing. (Don't crush my n00bling hopes too soon
)Criticisms? Questions? Comments?
Edit: URL update, left out critical coupler and bushing:
http://img151.images...sicrifle1da.png
P.S. Couldn't get the picture to upload in the forums to proper size...only the URL works like I want it too, sorry guys.
Edited by Mr. Zarwid, 23 June 2006 - 10:32 PM.
