3 replies to this topic

[Mattf]

Here's the picture. I just used a rough piece of tubing to slowly grind away a bit of plastic from the walls on the original barrel, and put it all in there. It looks good, and the brass doesn't wobble at all. Fantastic.

Would have been easier to drill it out, but this was late at night, and....

[SG Pilot]

Not bad, I see you are using stock darts, but if you make stefans, definately do. What are the approximate ranges of the gun right now with the stock darts? Is it better?
I had done a PVC barrel mod on my NF like Starbuck's Bulldog NF I think, but the ranges with stock darts have barely improved; Only 30 feet flat, I measured.

[Mattf]

I think what helps my ranges most would be the fact that I have all those rubber bands on it and the electrical tape around the plunger head. THEN the tight fitting barrel comes into play.

I have made stefans, I just haven't tried them with this yet

I can shoot the 30-40 feet across my basement accurately. I caliberated the red dot scope to hit perfectly at this range, very consistantly too. Stefans are inconsistant, that's why I don't like them.

Flat I'll have to check out. I measure them differently then others do I think... About 3' off the ground, against a table.

[NerfMonkey]

Actually, well-made Stefans can be just as accurate and get ranges just as consistent as stock darts. It just takes practice to make them well.

I'm not real fond of the black plunger and trigger, but that's not the point of the thread. It's still nice to see a surge of mods coming from new forum members.

Edited by NerfMonkey, 28 February 2006 - 04:56 PM.