4 replies to this topic

[Nerfy BuNNy]

One of my Airtech 3000's was messed up, in the barrel side, so I decided to just single barrel the darn thing.

For some reaosn, (this is my second at3k mod) I cannot remove the barrels. There is that stupid cross metal bar that doesn't allow you to pull out the darn barrels! >=(

I have used extensive amount of force. Small Pliers, Huge Pliers, Hammreing it, and it just WON'T move.

How can you remove this dumb set of orange barrels??? Please help me.

[nerfer34]

I believe your supposed to saw off the barrels to perform a mod.( If that's what you meant)

[Nerfy BuNNy]

I believe your supposed to saw off the barrels to perform a mod.( If that's what you meant)

im not trying to multi barrel.

I am attaching a PEX tube Directly to the spout of the airtank.

But, I cannot do that because the originals are in the way, and they are attached to the gun with a metal rod, that has another one going opposite to it.


Example:

=======|==

the "|" is the random other rod that is preventing me from pulling the darn thing straight out.

I cant hammer it out, and I cant saw it, and I have pulled and pushed, for hours.. I Need help!

DIAGRAM:

Edited by Nerfy_BuNNy, 04 February 2006 - 09:13 PM.

[nerfer34]

OK thanks for clearing things up. Have you tried pulling the bar from the rear instead of the front? What happens? How thick is the bar?

[Sunchip]

I recently singled one of mine, and had the same problem as you. What I did was take a hacksaw, and cut off both sides of the "crossbar" as close to the "bar" as I could. The bar was then thin enough for me to pull and twist it to get it and the turret off the airtank. Hope that helps.