So I was doing a mod on my first shot and I put e-tape around the plunger head and it wasnt going fast enough and wasnt producing the range I was supposed to get so I put some silicone spray in the plunger as it was cocked and fired. Then I went to pull again and it wouldnt go so the plunger head is stuck. I tryed to free it with a butload of soap and to clean the silicon out with so wd 40. Neither worked. So how would you get it unstuck?
-DTR
First Shot Help
Started by DTReaper, Jan 22 2006 05:54 PM
2 replies to this topic
#1
DTReaper
-
- Members
- 309 posts
Member
Posted 22 January 2006 - 05:54 PM
QUOTE(VACC @ Dec 5 2008, 12:09 AM) 
That's it. I'm done. I'm sorry there are breasts on the Internet.
#2
Forsaken angel24
-
- Contributors
- 2,472 posts
Member
Posted 22 January 2006 - 06:55 PM
Try heating the tube shaft with a blowdryer. This will expand the tube shaft and help free the plungerhead. Next time you want to use e-tape on a plunger head, Cut a thin strip of it and put it under the o-ring. I hope you didnt use jigaloo that shit will seize up stuff if it mixes with whatever lanard or nerf uses for lube.
I don't get my kicks out of you,
I don't feel the way I used to do.
I know its bad,
After what we had,
But I’m just not the angel you knew.
I don't feel the way I used to do.
I know its bad,
After what we had,
But I’m just not the angel you knew.
#3
DTReaper
-
- Members
- 309 posts
Member
Posted 22 January 2006 - 07:04 PM
Nevermind I got it out but pushing on the top sides of the plunger head.
-DTR
-DTR
QUOTE(VACC @ Dec 5 2008, 12:09 AM)
That's it. I'm done. I'm sorry there are breasts on the Internet.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
