5 replies to this topic

[man with many guns]

All right, so you all know the story with this gun, lets get down to moding it. Here’s the gun stock:
Tools needed:
6in. of ½ inch cpvc
Phillips screwdriver
Hot glue gun
Hammer
Something to pry/smash the orange caps off

1. Surprisingly, the hardest step. Do what ever you can to get the orange caps off (dremel, file, smash, pry, melt, just whatever you can). Then remove all the screws.

2. Take the pump out, and plug it with your hot glue gun. It should look like this (sorry the pic is low quality):
3. Cut the your cpvc with a hack saw, then file the ends.
4. Take the cpvc and pound it down in the valve, and place a ring of hot glue around the cpvc, and it should look something like this:
5. Place all the internals back in the case.

6. Screw the case back together. Now you have a foamy weapon of doom!

[Forsaken angel24]

What are the ranges and how many recomended pumps?

[TED]

What are the ranges and how many recomended pumps?

Just check Cxwq's mod.

[Uncle Hammer]

Barrel looks crooked.

[Forsaken angel24]

What are the ranges and how many recomended pumps?

Just check Cxwq's mod.

Would normally seem like sound advice. If you read Cxwq's mod you would notice he used petg instead of cpvc. This Cpvc is a variable that will affect range. Although it did answer one the pump question. So once again, this time the question directed at man with many guns. What are the ranges?

[man with many guns]

The barrel isn't crooked, its just the pic.
The recemended pumps are 3-4 pumps, and I get estimatedly 90-95 feet. I don't have a tape mesure long enough to mesure it.
Cxwq's mod was the new one, so that could have effected it to.