So what i was going for was the ability to turn your Rapid Fire Rifle into a Bolt Action Rifle...or slide...or whatever.
WHAT YOU NEED:
1 2-Inch Nail
1 pound Ground Beef
Lets take the first cut! You see when you ride that lever down a yellow tube goes out the back.
You need to cut out a line in the green marked in this picture with red, make sure its lined up with the screws on the yellow tube, You can take the whole gun apart and cut it or you can cut it in while the gun is still all in one piece. Now you have a guide for the bolt...
Uh oh...wheres the bolt?
Once your done hey your half way there. Now the yellow tube has screws in it unscrew the one which is closest to the end of the tube marked in the pic. Than drill with a bit a tad bigger than the hole already given, And than Find a 2-Inch Screw and screw it in there. And now you have a bolt.
Now if you put the screw in right, If the bolt guide was cut right. Than the screw you put in (Bolt) should slide in and out of the gun seamlessly!
Lets make our last cut, LETS GET THAT LEVER....OOUUTA HERE!!!
Probably the smartest thing BUZZBEE ever did to there products was make an aluminum lever, damnit that thing is sturdy but easy too cut, My Coping Saw took it down, SO cut it as close to the green thing as possible.
Sand it down as smooth as possible because metal gets sharp after you cut her down.
And you are finished! To ensure More efficiency Take out the barrel break at the end of the barrel.
This is how it looked when it was finished.
Edited by joeyaglr444, 14 March 2008 - 09:54 AM.