Jump to content


Photo

What Kinda Gun Is This?


3 replies to this topic

#1 Nerf punk837

Nerf punk837

    Member

  • Members
  • 3 posts

Posted 16 June 2003 - 03:02 PM

i went over my friends house today who is wanting to get into nerf and while we were in his basement we found an old piece of sh** gun. it shoots balls and is an older model. the name i don't no. but however it looks like a ballzooka but only has 2 barrels. if someone could tell me what kind of gun this is and if anyone knows of any mods it would be greatly appreciated.
  • 0

#2 Groove

Groove

    Certified Badass

  • Founders
  • 1,673 posts
  • Fucks Given:0
  • Location:Irvine
  • State:California
  • Country:United States

Posted 16 June 2003 - 04:37 PM

Master Blaster.

You can't really mod a ball gun...might give it some oil on the pull plunger to make it smooth to pull, but besides that, no mods.
  • 0

"Too close for missiles, I'm switchin' to guns"


#3 Diablo

Diablo

    Member

  • Members
  • 289 posts
  • Location:Cleveland
  • State:Ohio
  • Country:United States

Posted 17 June 2003 - 05:59 PM

I've never done this, nor have I ever heard of anyone doing this, but perhaps you could make ball shaped grenades to launch out of it? It would probobly be very hard to do, and most likley not worth it (unless you make awsome grenades), but If you like the gun a whole lot, then go for it! You would also be helping out the NIC a lot in the grenade development area.
  • 0

-Diablo

NHQ Administrator | www.nerfhq.com


#4 THIRST

THIRST

    Member

  • Members
  • 1,099 posts

Posted 01 July 2003 - 01:32 PM

I know howta make a nade..... you can eaither get a film cartridge, put a spring in it to put pressure on the top, put foam in it, and close it...if you throw it than it pops and foam goes everywhere.

Now if you wanna be a bit more complicated you could get two film cartridges, fill one will vinegar, the other with baking soda, put saran rap(ot glad rap) over the one with vinegar and tighten with rubberbands so its water proof and it doesnt leak, then poke a smal whole about the size of this: ( ) in the cartridge with baking soda on the UNopened side. ducttape the two cartridges together, open side and saran rap side facing in. you can use more saran rap so no backing soda leaves out of the canister. When u want to use it, take that saran rap off take a long rod thin enought to fit in the whole, shove it in there tearing the saran wrap, and throw. Breaking the saran wrap mixes the baking soda and vinegar, creates a chemical reaction, and spurts everywhere comeing out of the whole you poked, whopefully covering your enemy in watery foam...works for me....
  • 0
ko


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users