1.Take your kettle and heat up alot of water.
2.water to avoid hassle Do it one part by one part tp avoid hassle the best bet is to take your gun apart.
3.By now Your water is boiling.Put it into a bowl or a container relative to the size of the part your using.
4. Take Tongs or unless you can Take that much heat grab the Specimen and put it into the Hot water.
5.Wait...for 30 seconds to a minute.
6. Take out the speciman and as you SHOULD see the Hot glue is melted again and while you still have time take a non marking tool and scrape it off gently unless you want scrape marks on your gun.If the Glue turns solid again put it in the hot water again.
Repeat until the glue is no more.
7. If done correctly you will have a gun that looked like you never made a mistake on.
Hope this helps yall
Edited by joeyaglr444, 13 November 2005 - 10:35 AM.