3 replies to this topic

[notorious oxide]

I was just wondering if anyone has tried placing small barrels on the clip. i have been thinking about doing this to my new pc (which i got for $5AU) but i thought that there probly wouldnt be enough air flow to increase the range. I have not done anything to it except remove 1 peg so i could fit a stefan in.

Edited by notorious_oxide, 06 October 2005 - 08:17 PM.

[Beaver Vortex]

I don't see any point in messing with the clip aside from making it removable and taking out the pegs. It's not like it's going to improve air flow or anything.

[taita cakes]

The extra barrels will need you to remove the entire front section so that the barrels can move up with the clip. The added weight will also cause some serious problems for the pistons driving the clip meaning it will jam a whole lot more.

If you just want to have two permanent barrels at the top, this will not work unless you REALLY descreases the shooting speed. Mainly because the clip moves upward then shoots, and in rapidfire mode adds somewhat of an upward movement to the dart. You'd need to single shot it and make a decent seal or something.

[Team Slaya]

Maybe, if you really adore your PC and have access to 17/32 brass, you could try making a really tight fit with your darts. I've found that 17/32 goes pretty nicely in the PC clip, maybe if you wrap a little tape around it it'll be nice and snug. I had a 2" piece of brass sitting around, and it happened to be just the right length to fit in. I'll edit if I actually do it, and I'll compare ranges.

TS