Jump to content


Photo

Sspb

Tank Troubles.

3 replies to this topic

#1 Team Slaya

Team Slaya

    Member

  • Members
  • 615 posts
  • Location:Massachusetts

Posted 30 September 2005 - 09:59 PM

I recently drilled a hole into my SSPB's tank, as Lefty @ NHQ did, to increase the size of the airtank. But now it seems that the opening that pulls back to let the pressure out is stuck in the open position, and I can't seem to get it back to normal. Any suggestions?

TS
  • 0

#2 Forsaken angel24

Forsaken angel24

    Member

  • Contributors
  • 2,471 posts

Posted 30 September 2005 - 10:23 PM

Spend the $3.00 and get a new one.
  • 0
I don't get my kicks out of you,
I don't feel the way I used to do.
I know its bad,
After what we had,
But Iím just not the angel you knew.

#3 LordoftheRing434

LordoftheRing434

    Member

  • Members
  • 565 posts
  • Location:Duluth/Minneapolis, MN

Posted 30 September 2005 - 11:23 PM

I haven't had too much experience with SSPBs, but it sounds similar to a situation I had with my AT2k. Does the thing actually have a firing pin? If so, that happened to me. I just wiggled the pin around for a while until it seemed to fall back into place. My 2k doesn't get its former distance, but it's still functional. Best advice I can give is to mess around with it a little more, or as FA said, buy a new one. If there isn't a firing pin, then this is completely pointless.

~Rings
  • 0
And when he gets to Heaven, to St. Peter he will tell, "One more soldier reporting sir, I've served my time in hell."

"I bluff it. I don't throw my weight around and say I know what I'm doing." ~ Mick Jagger

#4 rusty

rusty

    Member

  • Members
  • 159 posts

Posted 01 October 2005 - 09:50 AM

Turn it upsidown(so the barrel is facing the floor) and shake it while pumping. That's always worked for me.
  • 0


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users