#1
Posted 17 September 2005 - 12:20 PM
S Bills
#2
Posted 17 September 2005 - 12:37 PM
#3
Posted 17 September 2005 - 12:44 PM
Don't call it a comeback, I never left.
#4
Posted 17 September 2005 - 07:26 PM
I also went around 5/16" under the line, and my 9/16" brass fit in just fine, but that will cost you more money (~$6 for two feet of brass at my local Ace Hardware), and you should be able to get PETG to work.
gets to your house before the police.
#5
Posted 17 September 2005 - 11:00 PM
Also, I don't have a dremel and aren't dremels really expensive?
#6
Posted 17 September 2005 - 11:04 PM
-or-
100% Nerf, for 100% pwnage.
Nerf is a neutral weapons dealer. Anyone coughing up the dough can get armed.
and they're made of Foam... which makes them very Nerfy...
#7
Posted 17 September 2005 - 11:21 PM
#8
Posted 17 September 2005 - 11:43 PM
Yes, the Dremel moto tools I see at Home Depot are usually selling for 60+ dollars.
Here's a picture of a file.
I wouldn't worry too much about getting the "barrel stuff and sandpaper" inside the gun, because the gun can get cleaned out...just make sure you avoid getting any in the air tank.
gets to your house before the police.
#9
Posted 18 September 2005 - 10:23 AM
DO you think 7/16 ID would be too small or still usable for good distances on the at3k.
Edited by S Bills, 18 September 2005 - 10:27 AM.
#10
Posted 18 September 2005 - 10:56 AM
I think that that depends on the particular Foam Backer Rod that you're using to make darts (assuming that you're using micro stefans)...7/16" ID wouldn't fit my 1/2" FBR very well, and if it fits yours, I'm guessing it'll be a little on the tight side.DO you think 7/16 ID would be too small or still usable for good distances on the at3k.
Where are you getting your PETG (I'm just curious, never used PETG myself)?
gets to your house before the police.
#11
Posted 18 September 2005 - 11:09 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users