I'm modding my NF with a 4'' 1/2'' PVC barrel. On this modifications section, it says just to glue it to the air restrictor and assemble the gun again.
The problem with this is that the barrel is toomlarge and the gun will not fit up together because it isn't fitting. The barrel is too wide. What's with this? Did I get the wrong barrel?
Barrel Too Big?
Started by Omicron, Jul 12 2005 08:51 PM
3 replies to this topic
#1
Posted 12 July 2005 - 08:51 PM
#2
Posted 12 July 2005 - 08:54 PM
The site uses PETG, which is thinner than PVC. You have to sand down some of the casing to get PVC to fit in.
~ompa
~ompa
#3
Posted 12 July 2005 - 09:09 PM
Thanks for the quick reply.
One further question: I don't have access to any kind of dremel or almost any kind of electric tool for that matter. Would it be possible to use a crayola as a bridge between the PVC and the plunger? What I'm saying is glue the crayola to the air restrictor, then outside the gun, just slide in the PVC barrel. How effective would this be?
One further question: I don't have access to any kind of dremel or almost any kind of electric tool for that matter. Would it be possible to use a crayola as a bridge between the PVC and the plunger? What I'm saying is glue the crayola to the air restrictor, then outside the gun, just slide in the PVC barrel. How effective would this be?
#4
Posted 12 July 2005 - 09:09 PM
That should work just fine.
~ompa
~ompa
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users