First, you’re going to want to take this piece and your turret out of your RF20.
Next, take your Nitefinder apart, and get the plunger tube.
Then, cut down your little piece from the RF20 that has 2 holes down to about a centimeter or two. Also, make sure you cut of the little “wings” on the piece. Then, glue that piece on, and MAKE SURE that it is vertically aligned with the little ridge on the plunger, like this:
Next, cut the casing around these lines- the little horizontal cut where the light used to be is designed to hold the little cross on the back of the turret.
After the cut, put everything back in.
Next, disassemble your turret.
Then, slide your turret into the slots you cut into the casing, and make sure you line it up with the plunger, so the holes line up with the holes. Then, glue the turret in place with some really strong glue- I used hot glue because I was out of epoxy, again.
Then, just glue on your 17/32 brass barrels, and you’re good to go. I used lengths of approximately 2.5 inches, but your lengths may be different. The only problem with the gun is that you need to hold the turret back against the plunger when firing, so it’s kind of a 2-handed weapon. However, it still works really well, since all you need to do is prime, then hold/fire. It should reach ranges of about ~60-65’ when finished.
~ompa
Edited by ompa, 11 July 2005 - 01:12 PM.
