I am modifying my hornets barrels but one of the pieces is stuck. I have pulled out the poles with pliars and drilled through the piece that holds the pole but there is a three-pronged piece behind that that won't come out. I can't get it with pliars because I'm keeping the stock barrels on and I have tried prying it out with a piece of wire but its stuck. Can I drill throuh this or do I have to pull it out? Does any one know how to get this out? Also after the three-pronged piece how much farther do I drill?
Hornet Question?
Started by navy seal, May 29 2005 11:08 AM
2 replies to this topic
#1
Posted 29 May 2005 - 11:08 AM
Played in 110 countries
Bigger than rugby
Bigger than snowboarding
Bigger than surfing.......Paintball
Bigger than rugby
Bigger than snowboarding
Bigger than surfing.......Paintball
#2
Posted 30 May 2005 - 12:10 PM
Why are you leaving the stock barrels on? Do Ompa's mod. He gets 80' with 20 pumps. I don't see why you woule leave them on, but its your choice.
#3
Posted 30 May 2005 - 12:47 PM
I'm going to replace the stock barrels with cpvc. I cut them off but I have to go buy a sanding piece because the ones I have are to small or worn out.
Played in 110 countries
Bigger than rugby
Bigger than snowboarding
Bigger than surfing.......Paintball
Bigger than rugby
Bigger than snowboarding
Bigger than surfing.......Paintball
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users