No replies to this topic

[LiKnSmAkScOmIn]

So, I'm working on rebirth of my SM500 and putting it into the shell of a newstyle 1500.

Here's the thing:
The firing pin doesn't go all the way back in after I pull it back, but this can be solved with a rubber band.
The firing pin can wiggle, and sometimes if I move it around air leaks.


The reason I'm asking for JLego/Black Wrath is because I know you two have dissected an SM5000 valve which is the same construction as the valve on a SM500.

My question: Is the hook at the end of the firing pin supposed to be glued onto the piece holding the rubber seal? I cut the pump off the airtank, and noticed it can move around quite a bit.

Stolen from JLego's old topic, this is the pin+hole I'm talking about.
http://img53.imagesh...ofopenvalve.jpg